knife edge

英 [ˈnaɪf edʒ]

美 [ˈnaɪf edʒ]

adj.  形势难料的

机械

英英释义

noun

• the sharp cutting side of the blade of a knife
  Synonym:cutting edge

双语例句

• Universally analyzed and discussed in this paper is the visualization of inhomogeneous phase distribution of phase objects with spatial zero frequency filtering and knife edge filtering method.
  对空间滤波法的零频滤波与刀口滤波显示位相型物体的非均匀位相分布进行较为普遍且详尽的分析讨论，并给出一些实验结果。
• In this paper, the developing process, on hydraulic copying knife edge grinder was expounded.
  本文阐述了液压仿形刃口磨床研制的全过程，针对原有设备存在的缺陷，提出设计改装方案，进而付诸实施、取得结果。
• This paper introduces a new testing method of the surface shape of large optical mirror to replace Ronehi with Foueault knife edge.
  本文介绍了用刀口仪代替朗奇光栅用于大型光学镜面面形检验的新方法。
• His future remains on a knife edge
  他前途未卜。
• Suction outlet controlled by servo motor precision, following the knife edge automatic adjustment.
  吸风口由伺服电机精准控制，跟随边自动调整。
• This text has mainly proposed some discussion opinions on this processing method, explained its processing principle, set up mathematics model, proposed optimizing the design prospect of the excellent horn of knife edge to the improvement of the machining accuracy of the whorl finally.
  本文主要是对该加工方法提出了一些探讨性见解，并阐述了其加工原理、建立了数学模型，最后对螺纹加工精度的提高提出了优化刀刃优角的设计展望。
• A Self Contained Smart Depth Recorder A knife edge compensated ink-stylus
  微电脑自容式深度记录器尖刃补偿墨水笔描记录器
• On the basis of testing results, main cutting curves of wheat straw were given, under different cutting speeds of rotatory blade with different straw lengths, moisture centents cutting positions, different thicks knife edge, with and without shear bar.
  得出粉碎刀片在不同切割速度下，对短秆、长秆、秸秆不同切割部位、秸秆不同含水率、不同刀刃厚度、有定刀和无定刀等情况下的切断率曲线。
• The secret of successfully pressed hems is to use very little pressure so that the edge is not flattened to produce a knife edge.
  成功熨烫底边的窍门是用很小的压力，这样就不会倒伏而产生一条刃形边缘。
• Two series of fatigue crack growth rate ( FCGR) tests using three point bend specimen with different integral knife edge designs are performed. Effect of elastic modulus on the measurement of fatigue crack length using compliance technique is analyzed.
  用不同整体刀口设计的三点弯曲SE（B）试样做了两组疲劳裂纹扩展速率（FCGR）试验，分析了弹性模量在柔度法测量疲劳裂纹长度中的影响。